Sharp AR-5320 Service Manual - Page 6

Browse online or download pdf Service Manual for All in One Printer Sharp AR-5320. Sharp AR-5320 20 pages. Mono laser copier/printer
Also for Sharp AR-5320: Software Setup Manual (16 pages), Brochure & Specs (4 pages)

Print Page

[5]UNPACKING AND INSTALLATION

5. Changing a tray's paper size setting

Follow these steps to change a tray's paper size setting.

Note:

•The paper size setting cannot be changed when the machine has

stopped temporarily due to running out of paper or a misfeed, or during

interrupt copying.

•During printing (even in copy mode), the paper size setting cannot be

changed.

•A5 size paper can only be selected in upper paper tray.

•Do not load paper that is a different size than the paper size setting.

Copying will not be possible.

1) Hold down the [PAPER SIZE ENTER] key for more than 5 seconds to

set the selected paper size.

The currently selected paper feed location indicator will blink and the

corresponding paper size (which is currently set) indicator will light

steadily.

All other indicators will go out.

XTRA

2) If the machine has two paper trays, use the [TRAY SELECT] key to

select the paper tray for which you wish to change the paper size

setting.

Each time the [TRAY SELECT] key is pressed, a paper tray will be

indicated with a blinking paper feed location indicator.

3) Use the [ORIGINAL SIZE ENTER] key to select the paper size.

The indicator of the selected paper size lights up.

ENTER

TRA

4) Squeeze the lock lever of the front guide and slide the front guide to

•The front guide is a slide-type guide. Grasp the locking knob on the

guide and slide the guide to the indicator line of the paper to be loaded.

•The left guide is an insert-type guide. Remove it and then insert it at the

indicator line of the paper to be loaded.

•When using 11" x 17" sized paper store the left guide in the slot at the

left front of the paper tray.

5) Press the [START] key and then the [PAPER SIZE ENTER] key.

Note: Affix the paper size label for the paper size selected in step 3) to

Important points when using the printer mode

•Make sure that the tray's paper size setting is the same as the tray's

paper size setting in the printer driver. For example, if the tray's paper

size setting is A4R, set "Setting Paper Size" to "A4-R". For more

information, see "CONFIGURING THE PRINTER DRIVER" in the

"Software Setup Guide".

AR-5316/5320 UNPACKING AND INSTALLATION 5-1

match the width of the paper, and move the left guide to the

appropriate slot as marked on the tray.

Left guide

To change the paper size setting of another tray, repeat steps 2) to 5)

after pressing the [START] key.

the label position on the right end of the tray.

Front guide