Sharp AR-M160 Online Manual - Page 6

Browse online or download pdf Online Manual for All in One Printer Sharp AR-M160. Sharp AR-M160 33 pages. Digital document solutions
Also for Sharp AR-M160: Software Setup Manual (20 pages), Brochure & Specs (6 pages)

Print Page

Basic Printing

If the tray runs out of paper during printing

Add paper to the tray or press the [TRAY SELECT] key (

select a different tray, and then press the [ON LINE] key to

resume printing. Note that if the "Auto tray switching" setting in

the user programs is enabled and there is the same size of

paper in another tray, the machine will automatically switch to

the other tray and continue printing.

Pausing a print job

To pause a print job during printing, press the [ON LINE] key on

the operation panel to switch the machine off-line. Printing will

be paused and the ON LINE indicator will blink.

●

To cancel a print job, press the [CLEAR] key (

[CLEAR ALL] key

(

)

●

To resume printing, press the [ON LINE] key to switch the

machine online.

When the machine is connected to your computer using

Caution

the USB 2.0 (Hi-Speed) ports on each, be sure to read

"System requirements for USB 2.0 (Hi-Speed mode)" in

the Operation Manual.

CONTENTS

) or the

I N D E X

When "Paper Source" is set to "Auto Select"

) to

If "Paper Source" is set to "Auto Select" in the "Paper" tab of the

printer driver setup screen and the correct size of paper for a

print job is not loaded in the machine, the printing procedure will

vary depending on the "Use Close Paper Size" setting in the user

programs (see "USER PROGRAMS" in the Operation Manual).

When "Use close paper size" is disabled

The PAPER SIZE indicator on the

operation panel will blink. You can press

the [TRAY SELECT] key (

tray manually, or load paper in the

bypass tray and press the [ON LINE]

key to begin printing.

When "Use close paper size" is enabled

Printing will take place using a size of paper that is close to the

size of the print image.

●

When the dual function board is installed, the print image

Note

is automatically rotated to fit the paper in the event that

the paper is loaded in an orientation different from the

print image.

●

If the dual function board is not installed, be sure to set

each tray's paper size in "Set Tray Status" in the

"Configuration" tab of the printer driver setup screen.

(See "CONFIGURING THE PRINTER DRIVER" in the

Software Setup Guide.)

When printing, be sure to specify a tray other than "Auto

Select" in "Paper Source" in the "Paper" tab of the printer

driver setup screen.

(part 2)

ORIGINAL

PAPER

SIZE

) to select a

8½

5½

8½

EXTRA

SIZE