Sharp AR-M237 IMAGERs Key Operator's Manual - Page 21

Browse online or download pdf Key Operator's Manual for All in One Printer Sharp AR-M237 IMAGERs. Sharp AR-M237 IMAGERs 24 pages. Digital multifunctional imager
Also for Sharp AR-M237 IMAGERs: Specifications (2 pages), Software Setup Manual (18 pages), Software Setup Manual (20 pages), Quick Reference Manual (39 pages), Quick Reference Manual (39 pages)

Print Page

Sharp AR-M237 IMAGERs Key Operator's Manual

ENABLE NetBEUI

This program must be enabled to use the machine on

a network that uses NetBEUI protocol.

This program is initially enabled (factory default

setting).

RESET THE NIC

This program is used to restore all network settings to

the factory default settings.

PROGRAMS FOR PRINT MODE

INITIALIZE AND/OR STORE SETTINGS

(When the PRINTER EXPANSION KIT is installed)

These programs are used to return the configuration

settings (See the online manual for network printer)

and the "PRINT SETTINGS" (p.16) to the factory

default settings. The programs are also used to store

the current settings and to restore stored settings.

"INITIALIZE AND/OR STORE SETTINGS" consists of

the following programs:

G RESTORE FACTORY DEFAULTS

G STORE CURRENT CONFIGURATION

G RESTORE CONFIGURATION

Some programs in the following are marked

Note

by "*1". This indicates that a message will

appear at the end of the setting procedure

asking you to confirm execution of the new

setting. If needed, you can cancel the new

setting by touching the [NO] key.

RESTORE FACTORY DEFAULTS

This program is used to return the configuration

settings (see the online manual for network printer)

and the "PRINT SETTINGS" (p.16) to the factory

default settings. If you need a record of the current

settings before restoring the factory defaults, use

"Data list print" in the user settings to print a list of the

current settings. (See "CUSTOM SETTINGS" in the

operation manual for copier.)

STORE CURRENT CONFIGURATION

This program is used to store the current configuration

settings (see online manual for network printer) and

"PRINT SETTINGS" (p.16). The stored settings will not

be erased even if the power is turned off. To restore

the stored settings, use the "RESTORE

CONFIGURATION" program.

RESTORE CONFIGURATION

This program is used to restore settings that were

stored using the "STORE CURRENT

CONFIGURATION" program.

The current settings will change to the restored

settings.

If any of the "NETWORK SETTINGS" (p.18)

Note

were changed before execution of this

program, you must turn off the machine's

power switch, wait briefly, and then turn the

switch back on in order to make the settings

take effect.