Sharp SJ-B27S-SL Service Manual - Page 21

Browse online or download pdf Service Manual for Refrigerator Sharp SJ-B27S-SL. Sharp SJ-B27S-SL 33 pages.

Print Page

6-$6%6$6%6$6%6$6$6

CHAPTER 8.

SJD26LVSL

ASSEMBLING PROCEDURES OF MAIN PARTS AND CAUTIONS

CAUTION: DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE ANY REPAIRING.

[1] F-LOUVER ASS'Y (SJ-A20S/B21S/A24S/B25S/A28S/B27S)

1. Fan motor ass'y

Fan motor holder b

1. Stick U-sealer handle to Fan motor holder b (Fig. A-2).

2. Insert the terminal of Lead EV-cover to Fan motor (Fig. A-3).

3. Insert shaft of Fan motor to the hole of motor cushion, set at Fan motor holder b.

Then insert the boss of rear to the hole of Motor cushion, fix with Tapping screw(1 piece).

4. Set Fan clamp to propeller fan 90 mm. and then insert it to the shaft of Fan motor( Fig. A-4).

U-sealer handle

Fan motor holder b

WIRE COLOR IS GRAY/ORANGE

(127V : with yellow tape)

Fan motor

Lead EV-cover

Note

(1) Assemble so that terminal of Fan motor does not deform.

(2) Take care not to stress to terminals of Fan motor after wiring.

(3) Check locking by pulling them with more than 10N(1 kgf).

Lead EV-cover

Motor cushion

U-sealer handle

Fan motor holder b

SEC. A-A

U-sealer handle

Figure A-2

Figure A-3

Propeller fan 90

Fan motor holder a

Slit area

Motor cushion

Fan motor

U-sealer handle

Figure A-1

Propeller fan 90

Fan clamp

Propeller fan 90

GOOD

NO GOOD

Note

(1) Slit of each Fan Clamp and propeller fan 100 should not be at same

position.

(2) Fan clamp should be inserted virtically to the end of boss.

(3) Propeller fan should not be taken out from shaft when pulled by 2 kgf.

8 – 1

Fan clamp

Detail of D

Fan motor holder a

Fan motor holder b

Motor cushion

Fan motor

slit

Fan clamp

slit

Figure A-4