Digital Acoustics IP7-FD Getting Started Manual

Browse online or download pdf Getting Started Manual for Amplifier Digital Acoustics IP7-FD. Digital Acoustics IP7-FD 4 pages.

Print Page

IP7-FD

Getting Started Guide

Introduction

Digital Acoustics IP7-FD enables Full Duplex IP audio to support

simultaneous speaking in hands free conversation with TalkMaster™

software and/or VoIP Systems supporting industry standard SIP 2.0 (VoIP)

protocols. The "FD" is designed to work in tandem with Digital Acoustics'

"Full Duplex" call stations and enclosures for a compete 'endpoint' solution.

Standard features include PoE/External Power, Dual Ethernet ports and

Talk/Relay/Sensor connections.

The FD is configured using the TalkMaster Admin Console software. This

Getting Started booklet covers basic hardware installation and software

configuration of the IP7-FD.

Please refer to the IP7-FD Reference Manual available on the Software

Installation CD for additional information on installation and setup

Important Installation Guidelines

• Use two conductor 18-20 AWG twisted, shielded wire for Microphone

connections. The Microphone wire can not be in the same jacket as the

Speaker wire

• Select 18 AWG for Speaker connections. The TALK, RELAY and Sensor

wire wires may share the same jacket as the Speaker wire

• Avoid sharing AC power with audio in long conduit runs

• Do not install near power distribution equipment or noise generating

equipment such as stepper motors

• Conform to industry standard practices for grounding

IP7-FD Full Duplex - Call Station Installation

The IP7-FD is designed to be used with full duplex call stations supplied by

Digital Acoustics. Contact Technical Support for recommended design

criteria for other call stations.

• Connect MIC+ (J2-1) and MIC- (J2-2) from the IP7-FD to the Microphone

terminals in the call station. The Microphone wire can not be in the

same jacket as the Speaker wire

• Connect GND (J2-4) from the IP7-FD to the shield of the shielded wire on

the Microphone cable. Do not connect the shield at the call station

• Connect SPKR 8Ω+ (J2-6) and SPKR 8Ω- (J2-7) from the IP7-FD to the

terminals of the 8 ohm speaker in the call station (polarity independent)

• Connect TALK (J2-5) from the IP7-FD to one contact on the call station's

TALK button

• Connect the 2nd contact of the call station's TALK button to GND (J2-4).

Or connect the 2nd contact of the call station's TALK button to either of the

speaker terminals in the call station

Page 1 of 4

IP7-FD Installation