Shimano ALFINE Inter-11 Dealer's Manual - Page 5

Browse online or download pdf Dealer's Manual for Bicycle Accessories Shimano ALFINE Inter-11. Shimano ALFINE Inter-11 49 pages.

Print Page
Shimano ALFINE Inter-11 Dealer's Manual
TO ENSURE SAFETY
For installation to the bicycle and maintenance
• When installing the hub to the frame, be sure to install the correct non-turn washers to the left and right sides, and securely tighten the hub nuts to
the specified torques. If the non-turn washers are installed on one side only, or if the hub nuts are not tightened sufficiently, the non-turn washer may
fall out, which could cause the hub axle to rotate and the cassette joint to turn, resulting in the handlebars being accidentally pulled by the gear
shifting cable and an extremely serious accident.
• Assemble the wheel with 3x or 4x spoke lacing, and do not spoke the wheel radially.
Otherwise, the spokes or the wheel may get damaged, or noise may occur when braking.
< CT-S500 / CT-S510 >
• Never use alkali- or acid-based solvents such as rust cleaners. If those solvents are used the chain might break and cause serious injury.
• Clean the chain with an appropriate chain cleaner regularly. Intervals between maintenance depend on the use and riding circumstances.
• Use the reinforced connecting pin only for connecting the narrow-type chain. If connecting pins other than reinforced connecting pins are used, or if a
reinforced connecting pin or tool which is not suitable for that type of chain is used, sufficient connection force may not be obtained, which could
cause the chain to break or skip.
• If it is necessary to readjust the length of the chain due to a change in the number of sprocket teeth, make the cut at some other place than the place
where the chain has been joined using a reinforced connecting pin or an end pin.
The chain will be damaged if it is cut at a place where it has been joined with a reinforced connecting pin or an end pin.
• Check that the tension of the chain is correct and that the chain is not damaged. If the tension is too weak or the chain is damaged, the chain should
be replaced. If this is not done, the chain may break and cause serious injury.
End pin
Link pin
Reinforced connecting pin
5