Shimano Bell Crank III Service Instructions - Page 3
Browse online or download pdf Service Instructions for Bicycle Accessories Shimano Bell Crank III. Shimano Bell Crank III 4 pages.
Print Page
2)
Set the Revo-shift lever to
Next, pull the inner cable so that the edges of the link on the
main bell crank unit are between the two yellow lines on the
window, and then tighten the inner cable fixing nut at that
position.
2
Set to
Yellow line
Yellow line
Edge of link
The edges of the link
should be between the
yellow lines.
7.
Replace the bell crank cover and tighten the cover fixing screw.
.
2
Tightening torque:
4 – 6 Nm {40 – 60 kgfcm}
Inner cable
fixing nut
Tighten
After tightening the inner
cable fixing nut, cut off any
excess inner cable.
Within
4 mm
Installation of bell crank
1.
Insert the push rod into the hub axle.
Pull
The end of the push rod should project from
the end of the hub axle by approximately 14
mm.
2.
While pushing the main bell crank unit onto the hub axle, align the
serrations inside the main bell crank unit with the flange nut, and
then push the main bell crank unit on until it touches the end of
the hub axle. In this position, tighten the main unit installation bolt
onto the hub axle.
Tightening torque:
3 – 5 Nm {30 – 50 kgfcm}
Main unit
installation bolt
5 mm Allen key
or 10 mm
spanner
Edge of
window
Push rod
Approx. 14 mm
Flange nut
The edge of the window and
the end of the hub axle
should be aligned.
End of hub axle