Shimano ST-6510 Service Instructions Manual - Page 4
Browse online or download pdf Service Instructions Manual for Bicycle Accessories Shimano ST-6510. Shimano ST-6510 10 pages. Ultegra series shifter
Print Page
Installation
Installation to the handlebar
Secure the assembly with the installation nut on the outside
of the bracket. Pull the bracket cover back and use a 5 mm
Allen
key to tighten the bolt.
Installation of the brake cable
Cable used
• Inner cable (stainless steel)
• • • • • • •
• SLR outer casing
• • • • • • • • • • • • • • • • • • •
Be sure to leave some excess cable, even if cutting it to the
full length of the handlebars.
1.
Tilt the lever in (as when shifting) to make it easier to
pass the cable through the cable hook.
Note:
The front lever cannot be tilted to
the inside until lever b
once or twice.
Pull
Tilt
2.
Pass the inner cable through.
3.
Fix the outer guide to the inner cable, and set the angled
member in the bracket.
Note: Do not wipe the grease on the inner cable off.
Also, be careful that the inner cable does not pick
up dust and foreign matter.
Angled member of
outer guide
Bracket
Installation nut
Tightening torque:
6 - 8 N·m {50 - 70 in. lbs.}
f
1.6 mm
f
5 mm
is pushed
F
Lever
b
F
Cable hook
Inner cable
Inner cable
Outer guide
(Parts sold separately)
Bracket cover
5 mm Allen key
4.
Set the outer casing on the inner cable, and in the
bracket along the outer guide.
Make sure that the inner
end is firmly seated in the
cable hook.
Cable hook
Inner end
5.
Bring the outer casing along the front of the handlbar
and cover it with the outer guide. Now cut the outer guide
to the length of the handlebar, and tape it temporarily in
place.
Outer guide
6.
Finally, wrap the handlebar with the finish tape.
Outer casing
Cable guide
Outer holder
Outer casing
Tape