Digital Audio Labs LM-MICPRE Quick Start
Browse online or download pdf Quick Start for Amplifier Digital Audio Labs LM-MICPRE. Digital Audio Labs LM-MICPRE 2 pages. Intercom mic preamp
LM-MICPRE INTERCOM MIC PREAMP
QUICK START
v1.0
USING THE LM-MICPRE
The LM-MICPRE is a microphone preamp for using an external dynamic mic as an
alternative to the built-in intercom mics. Using an external dynamic microphone as
the intercom mic will provide a higher quality intercom with significantly reduced
background noise.
ATTACHING THE LM-MICPRE
1.
Connect the included USB cable and 1/8" TRS cable to the LM-
MICPRE and feed the loose ends through the MT-1.
2.
Connect the USB cable to the personal mixer USB port (front on the CS-
SOLO, back on the CS-DUO) and the 1/8" TRS cable to the AUX-IN port.
3.
If using the Livemix MT-1 mount, position the LM-MICPRE with the threaded mount holes "inside"
the MT-1. Use either the thumbscrews or Phillips head screws to fasten. If your Livemix personal mixer
is not mounted on a stand, use the Phillips head screws and attach the rubber support feet.
4.
Connect a dynamic microphone to the XLR connector on the LM-MICPRE with a standard XLR cable (not included).
CONFIGURING THE LM-MICPRE & EXTERNAL MICROPHONE
1.
PRESS Accessory Channels on the Channel Overview.
2.
PRESS and HOLD the Intercom Channel button.
3.
PRESS LM-MICPRE so the cell is gray and says "LM-MICPRE On".
4.
PRESS External Mic Setup.
5.
Speak into the external mic while adjusting the gain knob on
the LM-MICPRE. The Mic Level on the VU should be in the
yellow range when speaking at normal stage levels.
NOTE: If some users are using the built-in intercom and some are using external
microphones, you may need to adjust the gain knob on the LM-MICPRE to match
respective intercom volume levels.
INCLUDES:
LM-MICPRE
2x Thumbscrews
USB Cable
2x Philips Screws
1/8" TRS Cable
4x Rubber Feet