Digital Electronics FP790-T21 Installation Manual - Page 13

Browse online or download pdf Installation Manual for Monitor Digital Electronics FP790-T21. Digital Electronics FP790-T21 17 pages. Flat panel display

Print Page

Wiring the FP

• To prevent an electric shock, be sure to turn FP unit's main power supply OFF before attach-

ing the power cord terminals to the FP unit's power terminal strip.

• Be sure to use only the FP unit's rated power level. Using any other level of power can

damage both the power supply and the FP unit.

• Since the FP is not equipped with the power switch, be sure to connect a breaker-type

power switch to the FP unit's power cord.

• Use thick wire (2 mm

twisted near the ring terminals.

• Use ring terminals with the following dimensions:

• To prevent the power terminals from being short-circuited due to a loose

screw, use ring terminals with insulating sleeves.

Rear of FP

*1 L = Live line for AC input

N = Neutral line for AC input

FG = Ground terminal to be connected to the FP housing

Recommended ring terminal: V2-MS3 or equivalent

WARNINGS

max.) for the FP's power cable. Be sure that the cable is

L N

Ring terminal *1

- 13 -

L N FG

Power input

terminal block

(Manufactured by JST Co.)