Bitspower Touchaqua BPTA-WDP303C Installation Manual - Page 7

Browse online or download pdf Installation Manual for Accessories Bitspower Touchaqua BPTA-WDP303C. Bitspower Touchaqua BPTA-WDP303C 15 pages.

Print Page

Install the water tank flap

DRGB LED

Before use, please make sure that the mother-

board you choose has DRGB (Digital RGB)

lighting effect and its appropriate connector,

usually 3PIN. Or you can also use Bitspower's

lighting controller - BPTA-DRGBMFC.

TA-EXAIR-GS

Installation

TA-EXAIR-GS

It is recommended to

install the air-exhaust

fitting on the reservoir,

above the water line.

Step 1

Press the button to

release the air.

Black/M4 Screw

O-ring

BPTA-EFW-GS

Installation

BPTA-EFW-GS

It is recommended to install the

water-exhaust fitting at the lowest

point of the water cooling system.

Step 1

Unscrew the top of the water-exhaust

fitting.

Step 2

Replace with the water-exhaust part.

When screwing in the part, water will

start to discharge, it is recommended

to connect tubing beforehand to

control the water outflow.

P 2

angular adjustment

90°

The customized reservoir and water

pump should not be disassembled.

Disassembly will void the warranty.

Pump may be directly powered from the

power supply using a large 4PIN power

cord.

S1 Pump Spec.

Rated voltage：12V DC

Power consumption：17W

Maximum flow：960L/h

Maximum system temperature：60℃

PWM：NO

MTBF：50,000 hours

Warranty：2 years