Siemens SINAMICS G130 Operating Instructions Manual - Page 16

Print Page

Setting parameters with the BOP20

4.1 BOP20 overview

Table 4- 2

Keys

Key

Name

OFF

Functions

Parameters

Raise

Lower

Switches on the drives for which the command "ON/OFF1" is to be issued from the BOP.

Binector output r0019.0 is set using this key.

Switches off the drives for which the commands "ON/OFF1", "OFF2", and "OFF3" are to be

issued from the BOP.

The binector outputs r0019.0, .1 and .2 are reset simultaneously when this key is pressed.

After the key has been released, binector outputs r0019.0, .1 and .2 are again set to a "1"

signal.

Note:

The effectiveness of these keys can be defined by parameterizing the BICO (e.g. these

keys can be used to control all of the existing drives simultaneously).

The significance of this key depends on the current display.

Note:

The effectiveness of this key for acknowledging faults can be defined by parameterizing the

BiCo accordingly.

The significance of this key depends on the current display.

If this key is pressed for 3 s, the "Copy RAM to ROM" function is executed. The "S"

displayed on the BOP disappears.

The keys depend on the current display and are used to either raise or lower values.

Meaning

Basic Operator Panel 20 (BOP20)

Operating Instructions, 03/2013, A5E00809375A