Siemens TS1 Manual

Browse online or download pdf Manual for Industrial Equipment Siemens TS1. Siemens TS1 2 pages. Push button

Print Page
Bearing Kit
Genuine EZ Rebuild Kit
by
TM
1-800-726-7365
SI01KIT
107-2057
For EZ Rebuild Kits Or Tech Support, Contact 1-800-SCORE-OK or Visit www.ScoreDental.com
Required
!
Step 1
After reviewing the training video and step-by-step
instruction sheet, install the blank bur provided with
your EZ Press and check to make sure that the
spindle/chuck is holding the bur. If bur pulls out call
Score for replacement spindle/chuck.
Step 3
Locate the EZ Push-Button Protector that was included
with the press. Insert the skinny end up into the Spindle
Ram on the left and hold in place with your fingers.
Slowly pull the handle down until the protector meets
the rear of the spindle and covers the button.
Step 5
The old bearings and impeller will remain sitting on Insert B.
Discard the bearings and inspect the impeller any chips,
cracks or worn blades. If the impeller has any damage call
Score for a replacement.
Impeller
O-ring
Front
Bearing
HSM343
HSM165
DR70B3L
Tools
EZ Push-Button
WARNING: Could result in handpiece malfunction
Siemens TS1 Standard PB is a tradename and is not affiliated with Score Intl.
Rear
Spindle
Bearing
DR70B3L
TSP525
B
Protector
(EZ301PBP)
O-ring
Headcap
HSM165
4
Cap Wrench
TST903
!
CAUTION: Could result in damage to parts
Step 2
Loosen headcap using appropriate cap wrench and
remove turbine. If head cap and turbine come out
together, separate and set head cap aside. Place Insert B
underneath the Spindle Ram on the left side of the press.
Place the turbine in the center of Insert B with the bur going
down through the hole in the center.
Step 4
Make sure everything is aligned and pull down or tap the
handle firmly to push out the spindle/chuck and disassemble
the turbine. The spindle/chuck will fall into the tray below.
Step 6
Place Insert #1 underneath the Bearing Ram on the right
side of the press. Open your rebuild kit and pick up one of
the bearings. Pick up the spindle/chuck and hold it so the
bur points up. Drop the bearing over the bur so the silver
shielded faces down, away from the bur and the black side
faces up.
Turbine
EZ
Install
Turbine
by
HSM855-70822
107-7037