Cisco WS-X45-SUP9-E Installation And Configuration Note - Page 2
Browse online or download pdf Installation And Configuration Note for Switch Cisco WS-X45-SUP9-E. Cisco WS-X45-SUP9-E 22 pages.
Print Page
Revised: January 4, 2018,
Installation and Configuration Note for Cisco Catalyst 4500
E-Series Supervisor Engine 9-E
Product Numbers: WS-X45-SUP9-E, WS-X45-SUP9-E=(Spare), WS-X45-SUP9-E/2(Redundant Supervisor)
This document describes the features of the Cisco Catalyst 4500 E-Series Supervisor Engine 9-E and provides information about
how to correctly install and remove or replace the module.
Table 1: WS-X45-SUP9-E Chassis Compatibility Information
Compatibility Information
Chassis compatibility
Minimum software requirements
Chassis slot restrictions
Bandwidth per slot
Safety Warnings
Safety warnings appear throughout this publication in procedures that may harm you if you perform them incorrectly. A warning
symbol precedes each warning statement. The warnings below are general warnings that are applicable to the entire publication.
2
Description
Cisco Catalyst 4500 E-Series Supervisor Engine 9-E is supported on the Catalyst
4503-E, Catalyst 4506-E, and Catalyst 4507R+E, Catalyst 4510R+E switch
chassis.
Cisco IOS XE Release 3.10.0E and ROMMON IOS Version 15.1(1r)SG14.
For the latest software release requirements, refer to the Cisco IOS Release Notes
for the Catalyst 4500-E Series Switches at this
c/en/us/support/switches/catalyst-4500-series-switches/
products-release-notes-list.html
• Catalyst 4503-E—Slot 1 only
• Catalyst 4506-E—Slot 1 only
• Catalyst 4507R+E—Slot 3 and slot 4 (redundant supervisor engines
supported)
• Catalyst 4510R+E—Slot 5 and slot 6 (redundant supervisor engines
supported)
48 Gbps per slot—on all supported chassis.
location:http://www.cisco.com/
.