Samsung 2233SW - Full HD Widescreen LCD Monitor Quick Start Manual - Page 12

Browse online or download pdf Quick Start Manual for Monitor Samsung 2233SW - Full HD Widescreen LCD Monitor. Samsung 2233SW - Full HD Widescreen LCD Monitor 21 pages. Quick guide (korean)
Also for Samsung 2233SW - Full HD Widescreen LCD Monitor: Quick Start Manual (22 pages), Specifications (2 pages), (Korean) Quick Start Manual (22 pages)

Print Page
Samsung 2233SW - Full HD Widescreen LCD Monitor Quick Start Manual
but the "Not Optimum Mode", "Recommended Mode 1600 x 900 60 Hz" message appears
for one minute and then disappears.
Please change to the recommended mode during this one-minute period.
(The message is displayed again if the system is rebooted.)
Q:
There is no image on the screen. Is the power indicator on the monitor blinking at 1 second
intervals?
A:
The monitor is in PowerSaver mode.
A:
Press a key on the keyboard to activate the monitor and restore the image on the screen.
A:
If there is still no image, press the '
activate the monitor and restore the image on the screen.
Q:
Connected using the DVI cable?
A:
You may get a blank screen if you boot the system before you connect the DVI cable, or dis-
connect and then reconnect the DVI cable while the system is running as certain types of graphic
cards do not send out video signals. Connect the DVI cable and then reboot the system.

I cannot see the On Screen Display.

Q:
Have you locked the On Screen Display (OSD) Menu to prevent changes?
A:
Unlock the OSD by pressing the [MENU/

The screen shows strange colors or just black and white.

Q:
Is the screen displaying only one color as if looking at the screen through a cellophane paper?
A:
Check the signal cable connection.
A:
Make sure the video card is fully inserted in its slot.
Q:
Have the screen colors become strange after running a program or due to a crash between ap-
plications?
A:
Reboot the computer.
Q:
Has the video card been set properly?
A:
Set the video card by referring to the video card manual.

The screen suddenly has become unbalanced.

Q:
Have you changed the video card or the driver?
A:
Adjust screen image position and size using the OSD.
Q:
Have you adjusted the resolution or frequency to the monitor?
A:
Adjust the resolution and frequency at the video card.
(Refer to the Preset Timing Modes).
Q:
The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by
referring to the OSD.
Troubleshooting
' button. Then press any key on the keyboard again to
] button for at least 5 seconds.