Siemens CD634GA 0 Series User Manual And Installation Instructions - Page 22
Browse online or download pdf User Manual And Installation Instructions for Oven Siemens CD634GA 0 Series. Siemens CD634GA 0 Series 36 pages.
Also for Siemens CD634GA 0 Series: Instruction Manual (32 pages)
Print Page
en Troubleshooting
Fault
Appliance prompting
you to fill water tank
even though water
tank full.
Appliance prompting
you to fill water tank
even though water
tank not yet empty/
appliance not prompt-
ing you to fill water
tank even though wa-
ter tank empty.
A message that
reads "Fill water
tank?" appears on
the display when the
appliance is in opera-
tion.
"Appliance heating
up" appears on the
display but the appli-
ance is not reaching
the selected temper-
ature.
When cooking with
steam, a lot of steam
is produced.
When cooking with
steam, a lot of steam
is produced and this
happens repeatedly.
Steam escaping from
ventilation slots dur-
ing cooking.
13.2 Replacing the cooking compartment
bulb
If the cooking compartment light has failed, replace the
cooking compartment bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
Never touch the ventilation openings.
▶
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
22
Cause and troubleshooting
Water tank not inserted correctly.
Slide the water tank in until it clicks into place.
▶
Detection system not working.
Call the after-sales service.
▶
Water tank dirty and moving water level indicators jammed.
Shake and clean the water tank.
1.
If the jammed parts cannot be freed, order a new water tank from our after-sales service.
2.
Water tank half full.
No action required.
Automatic calibration values are not optimal.
Restore the appliance's factory settings and repeat the procedure for initial configuration.
▶
→ "Basic settings", Page 15
→ "Before using for the first time", Page 8
a The next time you use the Steam function at 100 °C, the calibration process will run
automatically and more steam will be produced.
The appliance is being automatically calibrated.
No action required.
Appliance unable to calibrate itself automatically if cooking times too short.
Restore the appliance's factory settings and repeat the calibration process.
▶
This is standard procedure.
No action required.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance must be disconnected from the power
supply.
¡ The cooking compartment must have cooled down.
¡ You must have a new halogen bulb to replace the
old one.
1.
Turn the glass cover anti-clockwise to remove it .
Pull out the halogen bulb without turning it .
2.
Insert the new halogen bulb and press it firmly into
3.
the socket.
Make sure that the pins are positioned correctly.