Siemens CM636GB 1 Series User Manual And Installation Instructions - Page 26

Browse online or download pdf User Manual And Installation Instructions for Oven Siemens CM636GB 1 Series. Siemens CM636GB 1 Series 40 pages.

Print Page
en Troubleshooting
Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
The operation does
not start or is inter-
rupted.
Appliance does not
heat up and "Demo
mode is switched on"
appears in the dis-
play.
The appliance does
not start and "Cook-
ing compartment too
hot" appears in the
display.
The time is not dis-
played when the ap-
pliance is switched
off.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The interior lighting
does not work.
Maximum operating
time reached.
A message with "D"
or "E" appears in the
display, e.g. D0111
or E0111.
The cooking result is
not satisfactory.
26
Cause and troubleshooting
Electronics fault
1.
Briefly disconnect the appliance from the power supply by switching off the fuse.
2.
Reset the basic settings to the factory settings.
→ "Basic settings", Page 19
There has been a power cut.
▶
Implement the settings for the initial configuration.
→ "Carrying out the initial configuration", Page 12
Malfunction
▶
Call the after-sales service.
→ "Customer Service", Page 27
Different causes are possible.
▶
Check any notifications that appear in the display.
→ "Displaying information", Page 13
Device is in demo mode.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and back on again.
2.
Switch off demo mode within three minutes in the
→ "Basic settings", Page 19.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
The cooking compartment is too hot for the selected dish or type of heating.
▶
Allow the cooking compartment to cool down and start again.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→ "Basic settings", Page 19
The drying function is switched on.
The LED light is defective.
Note: Do not remove the glass cover.
▶
Call the after-sales service.
→ "Customer Service", Page 27
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch off the appliance with
2.
Then use
​ ⁠ to switch on the appliance and set the required operation.
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 27
Settings were unsuitable.
Setting values, e.g. temperature or cooking time, depend on the recipe, quantity and food.
▶
Next time, set lower or higher values.
Tip: A lot of information about the food preparation and corresponding setting values
can be found on our website siemens-home.bsh-group.com .
​ ⁠ first.