Siemens WM N Series Manual - Page 27
Browse online or download pdf Manual for Washer Siemens WM N Series. Siemens WM N Series 44 pages.
Print PagePress the I button.
3.
The door will be locked.
The selected number of hours (e.g.
‰ h) is shown in the display panel
and counts down until the wash
programme starts. The duration of
the programme is then displayed.
The programme duration is
Note:
included in the selected "Ready in"
time.
During the timer count-down, you can
change the preselected number of
hours as follows:
Press the I button.
1.
Use the Ready in button to change
2.
the number of hours.
Press the I button.
3.
During the timer count-down you can
add or remove laundry as required.
The length of the programme is
Note:
automatically adjusted when the
programme is running.
Certain factors can affect the
programme length, e.g.:
Programme settings,
■
Detergent dosage (additional rinse
■
cycles if required due to foaming),
Load size/type of textiles (longer
■
washing for higher load and for
textiles which absorb more water),
Imbalances (e. g. due to fitted
■
sheets) are offset with several start-
ups of spin cycles,
Fluctuations in power supply,
■
Water pressure (infeeding speed).
■
www.devicemanuals.eu/
Additional programme settings
\
Additional programme
settings
The available settings vary depending
A d d i t i o n a l p r o g r a m m e s e t t i n g s
on the model.
You can find an overview of all settings
available for selection in each
programme on the supplementary sheet
for the operating and installation
instructions.
speed eco
(( ¦, ( speedperfect, ¦ ecoperfect,
speed eco)
Button with two possible settings for
adapting the selected programme:
speed
■
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more
energy than, the selected
programme, without the speed
setting.
Do not exceed the maximum
Note:
load.
eco
■
Energy-optimised washing by
reducing the temperature and
increasing programme duration
while achieving a washing result that
is consistent with the selected
programme, without the eco setting.
If you press the speed eco button once,
you select the speed setting. If you
press the button again, the eco setting
is activated. The respective symbol is
shown in the display when the setting is
activated. If you press the button again,
no setting is activated.
en
27