Siemens WM N Series Manual - Page 39

Browse online or download pdf Manual for Washer Siemens WM N Series. Siemens WM N Series 44 pages.

Print Page

Information on the display panel

Indicator/symbol

Œ has lit up

Œ is flashing

| has lit up

": ‚‰

": ƒ„

": „ƒ

The ä indicator light

for the Drum clean

program* is flashing

Other indicators and

symbols

Depending on the model

Cause/remedy

The temperature is too high. Wait until the temperature drops.

■

The water level is too high. It is not possible to add more laundry. Close the door

■

immediately, if necessary. Press the I button to resume the program.

Laundry may be trapped. Open and close the door again and press the I but-

■

ton.

If necessary, push the door closed or remove the trapped laundry and then

■

push it closed again.

If necessary, switch the appliance off and then on again; set a program and

■

apply the settings you require; start the program.

Turn on the cold water tap fully;

■

The supply hose is kinked/trapped;

■

The water pressure is too low. Clean the filter. ~ Page 37

■

The drain pump is blocked. Clean the drain pump. ~ Page 36

■

The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.

■

~ Page 37

There is water in the base trough; the appliance is leaking. Turn off the tap. Call our

after-sales service. ~ Page 42

is flashing alternately with "Ÿš at the end of the program.

Not a fault – the unbalanced load detection system has interrupted the spin cycle

because the laundry is unevenly distributed.

Distribute small and large items of laundry evenly in the drum. Run the spin cycle

again, if necessary.

The childproof lock is active – deactivate it. ~ Page 31

Run the Drum clean* program or a 60 °C program to clean and care for the drum

and the outer tub.

Notes

Run the program without laundry.

■

Use standard washing powder or a detergent that contains a bleaching agent.

■

To prevent foaming, only use half the amount of detergent recommended by

the detergent manufacturer. Do not use detergents intended for woollens or

delicates.

Switch the notification signal on/off ~ Page 33

■

Switch off the appliance, wait for 5 seconds and then switch it back on. If the indica-

tor/symbol appears again, call our after-sales service. ~ Page 42

www.devicemanuals.eu/

Faults and what to do about them