Siemens WU P Series Instruction Manual And Installation Instructions - Page 32
Browse online or download pdf Instruction Manual And Installation Instructions for Washer Siemens WU P Series. Siemens WU P Series 40 pages.
Print Page
Cleaning and maintenance
en
Put the service flap back on, lock it
5.
into place and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 2 litre of
water into dispenser II and start the
Single spin programme.
The drain hose at the siphon
is blocked
Turn the programme selector to $
1.
Off. Pull out the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
32
Filter in the water supply is
blocked
Release water pressure in the supply
1.
hose:
a) Turn off the tap.
b) Select any programme (except
Rinse and Spin).
c) Select the A Start/Reload
button. Allow the programme to
run for approx. 40 seconds.
d) Turn the programme selector to
$ Off. The appliance is switched
off.
e) Pull out the mains plug.
Clean the filters:
2.
a) Disconnect the hose from the
tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Disconnect the hose from the
rear of the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
3.
leaks.