Cisco 7925G - Unified Wireless IP Phone VoIP Installing Manual - Page 13

Browse online or download pdf Installing Manual for IP Phone Cisco 7925G - Unified Wireless IP Phone VoIP. Cisco 7925G - Unified Wireless IP Phone VoIP 21 pages. Wavelink avalanche management console
Also for Cisco 7925G - Unified Wireless IP Phone VoIP: Datasheet (8 pages), Release Notes (16 pages), User Manual (28 pages), Accessory Manual (20 pages), Accessory Manual (13 pages), Administration Manual (19 pages), User Manual (10 pages), User Manual (16 pages), Quick Manual (14 pages), Administration Manual (23 pages), Administration Manual (14 pages)

Print Page

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup

Charge Phone Battery Using USB Cable and PC

The following figure shows how to connect your phone to a PC to charge the phone battery.

Figure 5: Charge the phone battery using the USB cable and PC

Procedure

Step 1

Insert the phone connector on the USB cable into the phone.

Step 2

Insert the USB A-type connector into the USB port on your PC.

Step 3

Monitor the indicator light after the phone briefly displays USB Connected on the status line.

Step 4

If you see the Found New Hardware Wizard popup message, stop the wizard from opening when

connecting to USB port, using the following steps:

a) Click Next to use the wizard dialog box.

b) In the Update New Software dialog, click No, not this time, and click Next.

c) Click Install the Software automatically (Recommended) and click Next.

d) After a few moments, the Cannot Install This Hardware dialog displays. Click Don't prompt me again

to install this software.

e) Click Finish to close the dialog box.

Note