Cisco 7925G-EX Installing Manual - Page 17

Browse online or download pdf Installing Manual for IP Phone Cisco 7925G-EX. Cisco 7925G-EX 21 pages. Wavelink avalanche management console
Also for Cisco 7925G-EX: Datasheet (8 pages), Release Notes (16 pages), Accessory Manual (20 pages), Administration Manual (19 pages), User Manual (10 pages), User Manual (16 pages), Administration Manual (23 pages), Installation Manual (12 pages), Administration Manual (14 pages)

Print Page

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup

Bulk Provisioning

The Cisco Unified Wireless IP Phones support a Bulk Provisioning Utility. For more information, see the

Bulk Deployment Utility Guide at

792xBD.1-0-Readme.pdf.

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G

Startup

After charging the battery and configuring the wireless IP phone, you are ready to power on the phone and

connect to the WLAN.

To power on the Cisco Unified Wireless IP Phone, press and hold the Power On button until the phone begins

its startup process by cycling through these steps:

1 The phone displays the Cisco Systems screen.

2 The phone screen displays these messages as the phone starts up:

3 The following information displays on the main phone screen:

When the phone passes through these stages with no errors, the phone has started up properly. Now the phone

is in standby mode and is ready to place or receive calls.

The signal icon in the upper left corner shows the strength of the signal between the wireless access point and

the phone. The phone must have an adequate signal to successfully place or receive calls. If the signal icon

displays only one bar, the weak signal can cause problems with phone performance.