Siemens dishwasher Operating Instructions Manual - Page 26

Print Page

Siemens dishwasher Operating Instructions Manual

W arm water connection *

W a r m wa t e r c o n n e c t i o n

* depending on model

The dishwasher can be connected to cold

or hot water up to max. 60 °C.

Connection to hot water is recommended

if the hot water can be supplied

by energetically favourable means

and from a suitable installation, e.g. solar

heating system with circulation line.

This will save energy and time.

The hot water setting :

to adjust your appliance optimally

to operation with hot water.

It is recommended to have a water

temperature (temperature of the incoming

water) of at least 40 °C and no more than

60 °C.

It is not recommended to connect

the appliance to hot water if the water

is supplied from an electric boiler.

Setting hot water:

– Open the door.

– Switch on ON/OFF switch (.

– Hold down programme button # and

press START button ` until : ... is

indicated on the digital display.

– Release both buttons.

The LED for button # flashes and the

digital display h displays the factory

setting :

– Press programme button # until the

factory set value

the digital display h.

To change the setting:

– By pressing the 3 button, you can

switch the hot water setting off :

on :

– Press START button `.

The set value is saved.

– Close the door.

allows you

is indicated on

Electrical connection

– Connect the appliance to an

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See rating

plate for required fusing 92.

– The socket must be near the appliance

and freely accessible following

installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side to satisfy

the relevant safety instructions.

– The connection may be modified by

technicians only.

– A power cord extension may be

purchased from customer service only.

– Use only a residual current operated

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

– The appliance features a water

damage protection system. Please

note the system will not function

unless the power supply is connected.

Removing the appliance

Also observe the sequence of worksteps

here.

– Disconnect the appliance from

the power supply.

– Turn off the water supply.

– Disconnect the waste water and fresh

water connections.

– Loosen fastening screws for the

furniture parts.

– If fitted, remove the base panel.

– Pull out the appliance, carefully pulling

the hose behind.