Siemens dishwasher Instructions For Use Manual - Page 32

Browse online or download pdf Instructions For Use Manual for Dishwasher Siemens dishwasher. Siemens dishwasher 34 pages. Dishwasher
Also for Siemens dishwasher: Instructions For Use Manual (29 pages), Operating Instructions Manual (30 pages), Operating Instructions Manual (30 pages), Operating Instructions Manual (30 pages), Operating Instructions Manual (28 pages), Operating Instructions Manual (26 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (26 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (32 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (34 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (34 pages), Instructions For Use Manual (26 pages), Operating Instructions Manual (40 pages), Instructions For Use Manual (31 pages), Instructions For Use Manual (40 pages), Operating Instructions Manual (24 pages), Operating Instructions Manual (28 pages), Operating Instructions Manual (28 pages)

Print Page
Siemens dishwasher Instructions For Use Manual
en

Fresh water connection

Using the enclosed parts, connect the
fresh water connection to the tap
according to the installation instructions.
Ensure that the fresh water connection is
not kinked, crushed or twisted.
When replacing the appliance, always
connect a new water supply hose to the
water supply. The old supply hose must
not be re-used.
Ensure that the fresh water connection is
not kinked, crushed or twisted.
Water pressure:
Minimum 0,5 bar – maximum 10 bar.
If the water pressure is higher, install a
pressure reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water.
If you do use hot water, the temperature
should not exceed 60 °C.

Electrical connection

This appliance should only be connected
to a 230/240 V AC source via a properly
installed earthed socket. See nameplate
for size of required fuse.
33
The socket must be installed close to the
dishwasher.
If the domestic wiring includes a residual-
current-operated (FI) circuit-breaker, make
sure that it bears the
this type conforms to the latest regulations
32
mark, as only

Disconnecting the dishwasher

Here too, it is important that tasks are
carried out in the correct sequence:
always unplug the appliance from the
mains electricity first of all.
Pull plug out of wall socket.
Turn off water supply.
Disconnect drain and water input hoses.
Remove screws in underside of work
surface. Detach base board, if fitted.
Pull out appliance and carefully withdraw
hoses at same time.
Transportation
Empty the dishwasher according to
the following steps:
Turn on the tap.
Switch on the appliance.
Start any automatic programme
and close the appliance door.
Wait until approx. 4 minutes have
elapsed.
Then open the door, terminate
the programme and close the door
to drain the appliance.
Wait until the buzzer is emitted 5 times,
i.e. all the water has been drained.
Switch off the appliance.
Turn off the tap.
Secure loose parts prior to transportation.
Transport the appliance upright only.
Otherwise, residual water may penetrate
the control and damage the appliance.
Protection from freezing
temperatures
If the appliance is installed in a location
where there is a risk of freezing
temperatures (e.g. in a holiday home), all
water must be completely drained out of
the interior (see "Transporting the
dishwasher").
Turn OFF the tap, disconnect the supply
hose and allow to drain.