Siemens SX Series Operating Instructions Manual - Page 38

Browse online or download pdf Operating Instructions Manual for Dishwasher Siemens SX Series. Siemens SX Series 42 pages. Dishwasher
Also for Siemens SX Series: Operating Insructions (38 pages), Operating Instructions Manual (38 pages), Operating Instructions Manual (42 pages), Operating Instructions Manual (42 pages), Operating Instructions Manual (44 pages), Operating Instructions Manual (46 pages), Operating Instructions Manual (44 pages), Instruction Manual (48 pages), Operating Instructions Manual (40 pages), Operating Instructions Manual (42 pages), Operating Instructions Manual (44 pages), Operating Instructions Manual (40 pages)

Print Page
Siemens SX Series Operating Instructions Manual
en
Installation and connection

Drinking water connection

1. Fasten the drinking water connection
to the tap according
to the installation instructions using
the enclosed parts.
Ensure that the drinking water
connection is not kinked, crushed
or twisted.
2. When replacing the appliance,
always use a new water supply hose.
Water pressure:
At least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
Minimum 10 litres/minute
Water temperature:
Cold water; hot water max. temperature
60 °C.
38

Warm water connection *

* depending on model
The dishwasher can be connected
to cold or hot water up to max. 60 °C.
Connection to hot water
is recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with circulation
line.
This will save energy and time.
The hot water setting :
to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button P
until : ... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display )" displays the
factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
display )".
To change the setting:
1. By pressing the 3 button, you can
switch the hot water setting off :
or on :
.
2. Press START button P.
The set value is saved.
W a r m w a t e r c o n n e c t i o n
allows you
.