Siemens EC945RB90A User Instructions - Page 11

Browse online or download pdf User Instructions for Hob Siemens EC945RB90A. Siemens EC945RB90A 12 pages. Maintenance instructions

Print Page

Operating instructions

Burner locations

1. Medium burner

2. Medium burner

3. Wok burner

Depress control knob and turn anti-clockwise to "High

Burner ignition &

flame"position. Hold the knob down for a few seconds

control

until the flame ignites. Keep control knob depressed for

a few seconds to activate the flame failure device. If

ignition fails, depress knob again and wait for ignition.

Turn anti-clockwise to set the flame to the desired

intensity.

If ignition fails depress knob and try again. If flame is

not established in 15 seconds release the control

knob and open a door and wait 1 minute before

attempting a new ignition procedure.

All burners are fitted with a flame failure device which

shuts off the gas supply if the flame extinguishes for

any reason. To re-ignite, wait 30 seconds for any unburnt

gas to disperse before repeating the ignition procedure

described above.

To turn off the gas supply to a burner turn the control

knob clockwise to the "OFF" position. (Refer Fig.

The control knob is used to adjust the flame of the gas

burner.

"Low flame" graphic= lowest output

"High flame" graphic= higest output

If the ignition sparkers are dirty, this makes the burners

harder to light, so you should keep them as clean

as possible. Clean them using a small brush and

remember that the ignition sparkers must be treated

very gently.

4. Small burner

5. Rapid burner

6. Control Knobs

7. Big wok burner

Burner

Position

Graphic

1 3

)

There are two ways to carry out the connection to the main

gas line:

A. The hotplate can be connected with rigid pipe as

specified in AS5601 table 3.1.

B. Flexible Hose: If installing with a hose assembly, install

with a hose assembly that complies with AS/NZS 1869 (AGA

Approved), 10mm ID, class Bor D, no more than 1,2m long

and in accordance with AS5601. Ensure that the hose does

not contact the hot surfaces of the hotplate, oven, dishwasher

or any other appliance that may be installed underneath or

next to the hotplate. The hose should not be subjected to

abrasion, kinking or permanent deformation and should be

able to be inspected along its entire length with the cooktop

in the installed position. Unions compatible with the hose fittings

must be used and all connections tested for gas leaks.

The supply connection point shall be accessible with the

appliance installed.

WARNING: Ensure that the hose assembly is restrained

from accidental contact with the flue outlet of an under-

bench oven.

Before Leaving- Check all connections for gas leaks with soap

and water. DO NOT use a naked flame for detecting leaks.

Ignite all burners both individually and concurrently to

ensure correct operation of gas valves, burners and ignition.

Turn gas taps to low flame position and observe stability of

the flame for each burner individually and all together. Adhere

the duplicate data plate to an accessible location near the

hotplate.

When

satisfied with the hotplate, please instruct

the user on the correct method of operation. In case the

appliance fails to operate correctly after all checks have

been carried out, refer to the authorised service provider

in your area.

It should be expressly noted that we cannot accept any liability

for direct or indirect damage caused by wrong connection,

leakage or improper installation. When being repaired, the

appliance must always be disconnected from the mains supply;

if required, notify our customer service.