Cisco 7945G - Unified IP Phone VoIP User Manual - Page 9

Browse online or download pdf User Manual for IP Phone Cisco 7945G - Unified IP Phone VoIP. Cisco 7945G - Unified IP Phone VoIP 23 pages. Unified ip phone
Also for Cisco 7945G - Unified IP Phone VoIP: Preparing To Install (17 pages), User Manual (4 pages), Installation Manual (19 pages), Quick Manual (12 pages), Quick Manual (15 pages), Admin Manual (6 pages), Manual (9 pages), Quick Reference Manual (3 pages), Troubleshooting And Maintenance (25 pages), User Manual (42 pages)

Print Page

Retrieve Voice Messages

To retrieve voice messages:

1. Select an available Cisco Unified IP phone line by lifting the handset, pressing the speakerphone button, or pressing a line

button. Listen for the dial tone.

2. Press the Messages button, and follow the voice instructions.

Note

When you have one or more new messages, the message-waiting indicator (MWI) on your handset is lit. The MWI

works only if the MWI is configured on your phone.

Your company determines the voice message service that your phone system uses. For the most accurate and detailed

Note

information, see the documentation for voice message service.

Adjust the Volume for the Current Call

To adjust the handset, speakerphone, or headset volume for the current call:

1. During a call, press the Up or Down Volume button.

2. Press the Save soft key to apply the new volume level to future calls.

Adjust the Ring Volume

• Press the Up or Down Volume button while the handset is in its cradle and the phone is idle.

Select the Ring Type

To change the ringer sound:

1. Press the Settings button.

2. Press 2 for Ring Type, or use the Navigation button to scroll to Ring Type and press the Select soft key.

3. Use the Navigation button to scroll through the list of ring types. Press the Play soft key to hear samples.

4. Highlight the ring you want, and then press the Select soft key.

5. Press the Ok soft key to select your setting.

6. Press the Save soft key to save the setting, or press Cancel to exit to the previous menu without changing the setting.

7. Press the Exit soft key to go to the main directory menu.

To adjust the contrast in your LCD display:

1. Press the Settings button.

2. Press 1 for Contrast, or use the Select soft key.

3. Use the Down or Up soft key to change the contrast.

4. Press the Ok soft key

5. Press the Save or Exit soft key.

6. Press the Ok soft key to select your contrast setting.

7. Press the Save soft key to save the setting, or press Cancel to exit to the previous menu without changing the setting.

8. Press the Exit soft key to go to the main directory menu.

Note

In the following procedures, you might need to enter information using the keypad. Press the backspace (<<) soft key

to erase digits that you enter incorrectly.