Epson EasyMP Network Projection Operation Manual - Page 35

Browse online or download pdf Operation Manual for Projector Epson EasyMP Network Projection. Epson EasyMP Network Projection 40 pages. Multimedia projector
Also for Epson EasyMP Network Projection: Operation Manual (47 pages), Update Instructions (4 pages), Operation Manual (50 pages), Operation Manual (50 pages), Operation Manual (47 pages), Operation Manual (50 pages), Operation Manual (48 pages), Operation Manual (47 pages)

Print Page
Epson EasyMP Network Projection Operation Manual
An e-mail notifying the operator of a problem/warning/status is issued
If the projector experiences a problem or enters a status requiring
attention, an e-mail like that shown below is sent to the address
specified for Recipient mail address.
If there is more than one problem, warning, or status, the
corresponding messages are output to separate lines.
Item
E-mail subject
[Display name displayed in Grouping view or Detail list
view] Projector status notification
Body
<Display name displayed in Grouping view or Detail list
view> has entered the following status.
<Warning/error/status message (Please see the table
below)>
The details contained in the e-mail message can consist of the following.
Message
Internal Error
Refer to Reading the indicators.
s Projector's User's Guide
Fan error
Sensor error
Lamp Cover Open
Lamp failure at power
*
on
*
Lamp Error
Supply System Error
*
(Ballast)
High internal tempera-
ture error
Low air flow error
Air filter air flow sen-
sor error
Cinema filter error
Details shown
Remedy
Message
Shutter error
Cooling system error
(Peltier element)
Cooling system error
(pump)
High-temperature
warning
*
Replace Lamp
*
Lamp error
Lamp failure at power
*
on
Supply System Error
*
(Ballast)
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
Cinema filter warning
Shutter warning
Clean Air Filter Notice
No signal
No image signals are being received by the
projector. Check the connection status and check
that the power for the connected equipment is
turned on.
Other error
Stop using the projector, disconnect the power cable
from the electrical outlet, and contact your local
Auto Iris Error
dealer or the nearest address provided in the
Support and Service Guide supplied with the projector.
35
Remedy