Cisco Cisco 525 Administrator's Manual - Page 26

Browse online or download pdf Administrator's Manual for IP Phone Cisco Cisco 525. Cisco Cisco 525 28 pages. 5xx series
Also for Cisco Cisco 525: Administrator's Manual (28 pages), Quick User Manual (7 pages), User Manual (21 pages), Admin Manual (6 pages)

Print Page
Cisco Cisco 525 Administrator's Manual

Troubleshooting guide

We'll always aim to give you the best service possible. However, no system can be guaranteed
to run error-free all the time. Here are a few issues that may arise - and how you can solve them.
The handset shows an on-screen extension, but is also showing an amber light on the line key.
This means it's successfully downloaded its configuration but hasn't been registered on Horizon. It's
normally a local fault, where our IP traffic is being restricted in reaching our Session Boarder Controller.
In a case like this, please check the following before raising a fault:
Ensure all router port settings - as defined earlier in this document - have been implemented.
Check the setting especially on port 5060 and make sure that SIP ALG is disabled.
Eliminate LAN variables, ideally by plugging the handset directly into the router. If your router
does not provide power over Ethernet, make sure the only thing between the router and the
handset is the Power Over Ethernet switch and that all the wires and units are working correctly.
Make sure the handset is still assigned to a user on the Horizon Portal.
Plug the handset into a different port that you know definitely works.
If none of these solve the issue, call our support team - contact details are in the following section.
The handset boots up, but displays an amber light on the line keys and no on-screen extension
This means it's either been provisioned incorrectly, or it can't gain a connection to the public internet.
Try the following checks:
Ensure all router port settings - as defined earlier in this document - have been implemented.
Check the setting especially on port 5060 and make sure that SIP ALG is disabled.
Check you've assigned a local IP address, by looking it up on the routers ARP cache or similar.
Eliminate LAN variables, ideally by plugging the handset directly into the router. If your router
does not provide power over Ethernet, make sure the only thing between the router and the
handset is the Power Over Ethernet switch and that all the wires and units are working correctly.
Make sure the handset is still assigned to a user on the Horizon Portal.
Plug the handset into a different port that you know definitely works.
The information contained within this document, or subsequently provided, whether verbally or in documentary form, is confidential to Gamma and is provided to
the organisation named within this document only. It shall not be published, disclosed or reproduced wholly or in part to any other party without our prior written
consent. Gamma has made all reasonable efforts to ensure the accuracy and validity of the information provided herein and we make no warranties or
representations as to its accuracy. Gamma should be notified of all requests for disclosure of Gamma supplied information under the Freedom of Information Act.