Digital Matter Sting Getting Started - Page 3

Browse online or download pdf Getting Started for GPS Digital Matter Sting. Digital Matter Sting 4 pages.

Print Page

Digital Matter

Closing and opening the housing

The housing clips together and does not need screws

To close the housing, line up the top and bottom parts. Push the housing together firmly.

To open the housing, insert a flat screw driver into the opening highlighted above. Carefully

lever the two halves apart. A wider screw driver works better.

5. DEFAULT TRACKING SETTINGS

By default, the Sting is setup for trip tracking. The following default settings apply:

1. Out of Trip:

a. 12 hour heartbeats. This is a GPS point and upload every 12 hours.

2. In Trip:

a. Start trip threshold of 250m

b. Upload on trip start.

c. GPS points every 2 minutes

d. Upload every 30 minutes.

e. End a trip after 5 minutes of no movement.

Upload on trip end.

These are configurable in the OEM Admin Interface.

The defaults provide a good starting point. It is important to monitor and tweak your settings to

ensure the battery life is acceptable. Incorrect settings can flatten the batteries quickly. Contact

Support for help with this.

6. LIGHT TAMPER

Light is channelled to the light sensor through the clear light pipe in the housing. The device

uses two lux levels to determine tamper ON and tamper OFF. When the light level is above the

high level, tamper is ON. When the light level drops below the low level, the tamper switches

off. The difference between the high and low level provides some hysteresis.

The default settings for the tamper detection are disabled, to avoid excessive uploads.

Please use the OEM Admin Interface to enable the tamper detection and set the trigger levels.

7. TEMPERATURE, RELATIVE HUMIDITY AND LIGHT

The Sting has an on-PCB temperature, light and humidity sensor. The module can be

configured to read those 3 metrics periodically. It can log periodically, log on change, upload

periodically, and set high and low alarms.

The default settings for temperature, humidity and light sensing are OFF. To enable and

change the module parameters, please use the OEM Server Admin Interface.

Sting Getting Started

All information provided in this document is subject to legal disclaimers

Revision 1.0 - 3 July 2017

Sting Getting Started

Page 3 of 4