Cisco 10008 Quick Start Manual - Page 37

Browse online or download pdf Quick Start Manual for Network Router Cisco 10008. Cisco 10008 49 pages. Cisco systems router quick start guide

Print Page

Basic configuration setup is often used as a quick way to achieve network connectivity, allowing you to retrieve a

Tip

configuration file from a TFTP server.

Using the System Configuration Dialog

Use the System Configuration Dialog to help you perform a basic configuration. Proceed through the dialog by answering

questions and then pressing the Enter key. In most cases, you can get additional information by entering a question mark (?).

Throughout the dialog, default values are shown in square brackets ([ ]).

If you have experience using Cisco routers, consider configuring the router by using the procedure described in the

Tip

"Basic Configuration in Global Configuration Mode" section on page

To cancel the configuration dialog, press Ctrl-C, or you can let the dialog help you perform one of two configuration types:

• Basic configuration setup configures only enough connectivity for management of the system.

• Extended setup asks you to configure each interface and is not appropriate for configuring the Cisco 10008 router. For more

information, see the

You can run the setup facility any time you are at the enable prompt (#) by entering the setup command.

Basic System Configuration Procedure

Use the following procedure to perform a basic configuration using the System Configuration Dialog:

The dialog starts by asking if you want to continue with the configuration dialog. Enter Yes. To return to the enable

Step 1

prompt, enter No.

--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]: yes

Step 2

To perform a basic management setup, enter Yes. Enter No to perform an extended configuration setup.

Would you like to enter basic management setup? [yes/no]: yes

Specify a hostname. The hostname becomes part of the IOS prompt.

Step 3

Enter host name [Router]: my-router

Specify a secret password. It appears in encrypted form in the configuration file.

Step 4

Enter enable secret: my_secret

Specify the enable password. It is used if you did not assign a secret password.

Step 5

Enter enable password: my_password

Specify the password to use for Telnet sessions.

Step 6

Enter virtual terminal password: my_vt

At the configure system management prompt, enter No.

Step 7

Configure System Management? [yes/no]: no

If you want to access the router using SNMP, enter Yes at the prompt.

Step 8

Configure SNMP Network Management? [yes]: yes

Step 9

Specify an SNMP community string.

Community string [public]: public

Cisco IOS Configuration Fundamentals Configuration

39.

Guide.