Cisco 12006 series Replacement Instructions Manual - Page 29

Browse online or download pdf Replacement Instructions Manual for Network Router Cisco 12006 series. Cisco 12006 series 44 pages. Chassis replacement instructions
Also for Cisco 12006 series: Unpacking Instructions Manual (16 pages), Datasheet (9 pages)

Print Page

Reconnecting RP Cables

You must reconnect any cables that were disconnected from the RP console port, auxiliary port, or either

of the Ethernet ports, RJ-45 or MII.

Reconnecting Alarm Cards Cables

If you disconnected a cable from the external alarm port on either or both of the alarm cards, you must

reconnect those cables now.

To comply with the intrabuilding lightning surge requirements of GR-1089-CORE, Issue II, Revision 01,

Note

February 1999, you must use a shielded cable when connecting to the external alarm port on the alarm

card. The cable must consist of shielded cable terminated by shielded connectors on both ends, with the

cable shield material tied to both connectors.

Reconnecting Line Card Network Interface Cables

To reconnect network interface cables to a line card, see

Step 1

Attach an ESD-preventive wrist strap to your wrist and connect the leash to the chassis or to another

grounded, bare metal surface. (See

Step 2

Check your notes on the slot assignment and network interface cable information that you wrote down

before removing the line card.

Step 3

Orient the line card cable-management bracket so that the top of the bracket (the left end, where the

cables exit to the chassis cable-management bracket) is near the top (left end) of the line card faceplate.

Step 4

Align the two captive screws in the bracket with the threaded inserts near the ejector levers on the ends

of the line card faceplate.

Insert and tighten the two captive screws with your fingers, and then tighten the screw with a 3/16-inch

Step 5

flat-blade screwdriver.

Proceeding from the rightmost port to the leftmost port (on line cards with multiple ports only), identify

Step 6

the network interface cable for the line card port and insert the cable connector into the line card port.

Repeat

Step 7

Note

Carefully adjust the interface cables in the cable-management bracket to prevent any kinks or sharp

bends in the interface cable. Allow adequate strain relief in the interface cable. Kinks and sharp bends

can destroy or degrade the ability of the optical fiber to propagate the signal-encoded beam of light

accurately from one end of the cable to the other. Also, allow adequate strain relief in the interface cable.

Reconnecting Power to the Router

This section contains the following procedures:

•

78-16109-01

Step 6

for the remainder of the interface cables for this line card.

Reconnecting Power to a Router Equipped with the AC Power Distribution Unit

Reconnecting Power to a Router Equipped with the DC Power Distribution Unit

Figure 12

Figure

4.)

Cisco 12006 and Cisco 12406 Router Chassis Replacement Instructions

and follow these steps: