Cisco 1605 - Router - EN User Manual - Page 7

Browse online or download pdf User Manual for Network Router Cisco 1605 - Router - EN. Cisco 1605 - Router - EN 13 pages. 1600 series

Print Page

Compiled Fri 12−Jul−02 03:29 by pwade

Image text−base: 0x0803A50C, data−base: 0x02005000

ROM: System Bootstrap, Version 11.1(7)AX [kuong (7)AX], EARLY DEPLOYMENT

RELEASE SOFTWARE (fc2)

ROM: 1600 Software (C1600−BOOT−R), Version 11.1(7)AX, EARLY DEPLOYMENT RELEASE

SOFTWARE (fc2)

Router−1600 uptime is 3 days, 8 hours, 1 minute

System returned to ROM by power−on

System image file is "flash:c1600−y−l.122−10b.bin"

cisco 1604 (68360) processor (revision C) with 4608K/1536K bytes of memory.

Processor board ID 04607098, with hardware revision 00000000

Bridging software.

X.25 software, Version 3.0.0.

Basic Rate ISDN software, Version 1.1.

1 Ethernet/IEEE 802.3 interface(s)

1 ISDN Basic Rate interface(s)

U interface with external S bus interface for ISDN Basic Rate interface.

System/IO memory with parity disabled

2048K bytes of DRAM onboard 4096K bytes of DRAM on SIMM

System running from FLASH

7K bytes of non−volatile configuration memory.

16384K bytes of processor board PCMCIA flash (Read ONLY)

Configuration register is 0x2102

For more information, see Comparison of Cisco 1601−Cisco 1604 and Cisco 1605−R Memory Architectures.

Boot Sequence

All Cisco products do not have the same components or mechanisms to boot. This section describes the boot

sequence in the Cisco 1600 Series Router.

The boot ROM which is read−only memory contains two programs:

The ROM monitor or ROMmonThe ROMmon is a diagnostic image that provides the user with a

limited subset of commands. This diagnostic mode is most often used during recovery procedures

(forgotten password or wrong/corrupted Cisco IOS software). It is possible to view or modify the

configuration register from this mode and to perform a Cisco IOS software upgrade through the

xmodem transfer.

The Bootstrap (RxBoot)The bootstrap program is written to find and load a copy of Cisco IOS

software based on the settings of the configuration register. The Cisco IOS software image can be

located either on the system Flash, on a PCMCIA Flash card, or on a Trivial File Transfer Protocol

(TFTP) server. Usually, the Cisco IOS software image resides on the PCMCIA Flash card.

When a Cisco 1600 Series Router is first powered up, the boot−up sequence involves these steps:

ROMmon (in Boot ROM) takes control of the Main Processor and handles the following:

Control register settings.

Console settings.

Initial diagnostic tests of memory and other hardware.

Data structure initialization.

Flash file system (MONLIB) setup.

Cisco − Cisco 1600 Series Router Architecture