ActronAir Serene 2 RC-02 Operation Manual - Page 12

Browse online or download pdf Operation Manual for Remote Control ActronAir Serene 2 RC-02. ActronAir Serene 2 RC-02 16 pages.

Print Page

Operation Manual

06.03. Quiet Function

1. Press and hold the

indicate it is activated. The compressor will run at a reduced capacity to minimize the operational noise.

NOTE

Due to low compressor frequency operation, this may result in insufficient cooling and heating capacity.

2. Holding

3. Pressing the

06.04. Freeze Protection (FP) Function

In heating operation, the preset temperature of the air conditioner can be set to 8

temperature steady at 8

give the occupant a better head start when they go back home and turn ON the air conditioner.

While the system is in heat mode and 16°C, press the

indoor fan speed with temperature automatically set to 8

NOTE

The indoor panel and remote control will not indicate 8

06.05. LOCK Function

1. Press and hold the

above the set temperature to indicate that the remote control buttons are locked.

2. Press and hold the

NOTES

When pressing any button, the lock icon will flash to indicate that the remote-control buttons are locked.

All buttons are disabled whilst control has lock function ON.

06.06. BOOST Function

Boost function is available on heating and cooling to accelerate the time it takes to reach the set point.

06.07. ECO/GEAR Function

Press the

button to enter energy efficient mode in the following sequence.

ECO

GEAR (75%)

NOTE

This function is only available under cooling mode.

ECO Operation

1. While in cooling mode, press the

speed to save energy. Energy savings will take effect only when the initial set temperature is below 24°C.

2. If the set temperature is already above 24°C, the fan speed will change to Auto, the set temperature will remain

unchanged.

button for more than 2 seconds to activate Quiet Function. Quiet icon will display to

button again for 2 seconds turns off quiet function.

button will also cancel Quiet Mode.

C and will prevent the house from freezing when it is unoccupied in severe weather. This will

to cancel this operation.

buttons

Boost

and

buttons for at least 5 seconds to activate lock function. Lock icon will display

Humidity

Boost

and

buttons for 2 seconds to de-activate lock function.

Humidity

GEAR (50%)

Previous setting mode

button. The set temperature will automatically adjust to 24°C Auto fan

Operation Manual - Serene 2 Remote Controller

Document: 9590-4010 Ver. 1 200819

Remote Controller

buttons

twice within 1 second. The unit will operate at high

C and display FP on the indoor unit. Press the

C during FP Function.

ECO ......

C. This will keep the room