Cisco 2500 Series Getting Started Manual - Page 4
Browse online or download pdf Getting Started Manual for Network Router Cisco 2500 Series. Cisco 2500 Series 47 pages. Wireless controller
Also for Cisco 2500 Series: Installing Manual (12 pages), Configuration Manual (19 pages), Deployment Manual (23 pages), Configuration Manual (50 pages)
Print Page
About This Guide
Figure 2
controller.
It is expected that there will be small variations in LED color intensity and hue from unit to unit. This is
Note
within the normal range of the LED manufacturer's specifications and is not a defect.
Figure 2
Callout
CONSOLE
1
Cisco 2500 Series Wireless Controller Getting Started Guide
4
shows the front panel and location of the ports and light-emitting diodes (LEDs) for the 2504
Table 1
describes the components of the front panel.
Front Panel and LEDs
CONSOLE
CONSOLE
Table 1
Port and LEDs
CPU console port
GigE port and LED
CISCO 2500 Series WIRELESS CONTROLLER
1
2
3
4
1
2
3-4 POE
WLC2504 Front Panel Component Descriptions
State and Description
The CPU console port is an RS-232 port that supports a
RJ-45 connector. At boot-up the controller configures the
RS-232 port as a console port with default settings of
9600, N, 8, 1. The boot-loader supports baud rates of
1200, 2400, 4800, 9600, 19200, 38400, 57600, and
115200. A default baud-rate recovery mechanism is not
available; however the bootloader ensures that the stored
baud rate setting matches one of the allowed values
before setting the baud rate. If a nonstandard value is
detected the baud rate will default to 9600.
The Gigabit Ethernet port is an RJ-45 connector
form-factor. This port is designed so that 1500 VAC rms
isolation (per the 802.3 specification) is met between
chassis ground and any 48V/Ethernet signal.
LED description:
Green or Blinking Green—Link activity
•
Off—No link
•
Model 2504
RESET
PWR
SYS
ALM
RESET
PWR ALM
SYS