Cisco 2524 - Router - EN Configuration Manual - Page 18

Browse online or download pdf Configuration Manual for Network Router Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 pages. Troubleshooting guide
Also for Cisco 2524 - Router - EN: Configuration Manual (23 pages), Overview (10 pages), Preparing To Install (19 pages), Troubleshooting Manual (4 pages)

Print Page

Cisco 2524 - Router - EN Configuration Manual

Configuring the Router

Take the following steps to conﬁgure the 4-wire 56/64-kbps DSU/CSU WAN module for

DDS, substituting the correct addresses and host names as appropriate for your network:

Step 1

Step 2

Step 3

Step 4

Step 5

Conﬁguring the Fractional T1/T1 DSU/CSU WAN Module

This section describes how to conﬁgure the fractional T1/T1 DSU/CSU WAN module. This

module is conﬁgured for Extended Superframe Format (ESF) signal format, bipolar eight

zero substitution (B8ZS), and full bandwidth as the factory default. Depending on your

networking environment, you might need to change these settings.

For Cisco IOS Release 11.0 and earlier releases, refer to the Router Products Command

Reference for more information about the commands in this section. For Cisco IOS

Release 11.1 and later releases, refer to the Conﬁguration Fundamentals Command

Reference.

4-18 Cisco 2524 and Cisco 2525 Router User Guide

Enter enable mode:

Router> enable

password: enablepassword

Enter conﬁguration mode:

Router# config term

Router(config)#

Assign an IP address to the serial port on the module:

Router(config)# interface serial port_number

Router(config-if)# ip address ipaddress subnetmask

Router(config-if)# no keepalive

Set the network type to DDS:

Router(config-if)# service-module 56k network-type dds

Return to user EXEC mode:

Router(config-if)# exit

Router(config)# exit

Router# exit

Router>