Cisco 2524 - Router - EN Configuration Manual - Page 19
Browse online or download pdf Configuration Manual for Network Router Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 pages. Troubleshooting guide
Also for Cisco 2524 - Router - EN: Configuration Manual (23 pages), Overview (10 pages), Preparing To Install (19 pages), Troubleshooting Manual (4 pages)
Print Page
Take the following steps to configure the fractional T1/T1 DSU/CSU WAN module for a
typical leased-line connection, substituting the correct addresses and host names as
appropriate for your network:
Enter enable mode:
Step 1
Router> enable
password: enablepassword
Enter configuration mode:
Step 2
Router# config term
Router(config)#
Assign an IP address to the serial port on the module:
Step 3
Router(config)# interface serial port_number
Router(config-if)# ip address ipaddress subnetmask
Router(config-if)# no keepalive
Enter the framing type and line code type, substituting framing_type with sf
Step 4
(Superframe) or esf (Extended Superframe) and linecode_type with ami (alternate
mark inversion) or b8zs (bipolar eight zero substitution):
Router(config-if)# service-module t1 framing framing_type
Router(config-if)# service-module t1 linecode linecode_type
If you are using fractional T1 service, enter the time slot range and speed. In the
Step 5
following example, the time slot range is from 1 to 20 and the speed is 64-kbps:
Router(config-if)# service-module t1 timeslots 1-20 speed 64
Return to user EXEC mode:
Step 6
Router(config-if)# exit
Router(config)# exit
Router# exit
Router>
Configuring the Cisco 2524 and Cisco 2525 Routers 4-19
Configuring the Router