Cisco 2525 Configuration Manual - Page 16
Browse online or download pdf Configuration Manual for Network Router Cisco 2525. Cisco 2525 23 pages. Troubleshooting guide
Also for Cisco 2525: Configuration Manual (23 pages), Overview (10 pages), Preparing To Install (19 pages), Troubleshooting Manual (4 pages)
Print Page
Configuring the Router
Step 8
Step 9
Step 10
Configuring Switched 56
This section explains how to configure the 2-wire switched 56-kbps and 4-wire 56/64-kbps
DSU/CSU WAN modules for switched 56-kbps circuit-switched service.
You can configure the 2-wire switched 56-kbps DSU/CSU WAN module for
switched 56-kbps service, but not Digital Data System ([DDS], which are leased or
dedicated lines). The 4-wire 56/64-kbps DSU/CSU WAN module is configured for DDS as
the factory default, but it can be configured for either switched 56/64-kbps service or DDS.
(See the next section, "Configuring DDS.")
For Cisco IOS Release 11.0 and earlier releases, refer to the Router Products Command
Reference for more information about the commands in this section. For Cisco IOS
Release 11.1 and later releases, refer to the Configuration Fundamentals Command
Reference.
Take the following steps to configure the 2-wire switched 56-kbps and 4-wire 56/64-kbps
DSU/CSU WAN module for circuit-switched service, substituting the correct addresses and
host names as appropriate for your network:
Step 1
Step 2
4-16 Cisco 2524 and Cisco 2525 Router User Guide
Configure a static route to allow connectivity to the target router's local network.
Enter the network number of the target router's local IP network and subnet mask,
and the IP address of the target router's BRI port.
Router (config)# ip route targetrouter_ipnetwork subnetmask
targetBRIport_ipaddress
Enter the exit command to exit configuration mode.
Enter the copy running-config startup-config command to save the
configuration to NVRAM.
Enter enable mode:
Router> enable
password: enablepassword
Enter configuration mode:
Router# config term
Router(config)#