Cisco 2691 Series Quick Start Manual - Page 21

Browse online or download pdf Quick Start Manual for Network Router Cisco 2691 Series. Cisco 2691 Series 29 pages. Modular routers
Also for Cisco 2691 Series: Installing And Formatting (34 pages), Datasheet (8 pages), User Manual (48 pages)

Print Page
Cisco 2691 Series Quick Start Manual
Step 11 The configuration is displayed:
The following configuration command script was created:
hostname 2691
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
Step 12 Respond to the following prompts. Select [2] to save the initial configuration.:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
Step 13 The user prompt appears.
2691>
After you complete the initial configuration tasks, your Cisco router is ready to configure for specific functions. See the "Where
to Go Next" section on page 23 for information about locating documentation for advanced configuration procedures.

Initial Configuration Using the CLI (Manual Configuration)

This section shows how to bring up a command-line interface (CLI) prompt for configuration using the CLI, and it directs you
to documentation for the CLI configuration.You can use the CLI if you see the following messages at the end of the startup
sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file have been installed on the router at the factory. To use
SDM to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on
page 19.
21