Cisco 2811 - Voice Security Bundle Router Operations - Page 9
Browse online or download pdf Operations for Network Router Cisco 2811 - Voice Security Bundle Router. Cisco 2811 - Voice Security Bundle Router 31 pages. Integrated services routers
Also for Cisco 2811 - Voice Security Bundle Router: Quick Start Manual (45 pages)
Print Page
The cryptographic boundary of the module is the device's case. All of the functionality
discussed in this document is provided by components within this cryptographic boundary.
The interfaces for the router are located on the front and rear panels as shown in Figure 5 and
Figure 6, respectively.
The Cisco 2821 router features a console port, an auxiliary port, two Universal Serial Bus (USB)
ports, four high-speed WAN interface card (HWIC) slots, two10/100 Gigabit Ethernet RJ45
ports, a Enhanced Network Module (ENM) slot, a Voice Network Module (VeNoM) slot, and a
Compact Flash (CF) drive. The 2821 router supports one single-width network module, four
single-width or two double-width HWICs, has two slots for AIM-VPN/BPII-Plus cards
internal packet voice data modules (PVDMs), two fast Ethernet connections, and 16 ports of IP
phone power output. Figure 5 shows the front panel and Figure 6 shows the rear panel. The front
panel contains 4 LEDs that output status data about the system power, auxiliary power, system
activity, and compact flash busy status. The back panel consists of 13 LEDs: two Ethernet
activity LEDs, two duplex LEDs, two speed LEDs, two link LEDs, three PVDM LEDs, and two
AIM LEDs.
The front panel contains the following:
(1) Power inlet
(2) Power switch
(3) Console and auxiliary ports
2
The security policy covers the configuration in which one AIM card is used.
© Copyright 2007 Cisco Systems, Inc.
This document may be freely reproduced and distributed whole and intact including this Copyright Notice.
Figure 5 – 2821 Front Panel Physical Interfaces
Figure 6 – 2821 Rear Panel Physical Interfaces
9
2
, three