ACDC Dynamics SPF12-200 User Manual - Page 3

Browse online or download pdf User Manual for Battery Pack ACDC Dynamics SPF12-200. ACDC Dynamics SPF12-200 4 pages. Lithium battery

Print Page

SPF12-200

3． TRANSPORTATION AND STORAGE

Transportation:

1. Battery transportation temperature: 20 ~ 30˚C.

2. Batteries shall be packed in boxes for transportation, and vehicles such as cars, trains and cabins can be used.

3. During transportation, the battery shall not be subject to severe vibration, impact, exposure to moisture, inversion and heavy pressures;

4. The battery shall be handled with care during loading and unloading. Throwing, rolling, compressing and dropping of battery are strictly

prohibited.

Storage:

1. When the battery is not used for a long time (more than 3 months), please remove it from the device, charge the battery to the

semi saturated state, and then store it in a cool and dry room, and charge every three months.

2. It is strictly prohibited to store the battery at a low state of charge

3. The battery shall be stored in a dry and well ventilated place to avoid contact with corrosive substances, keep away from fire and heat

sources, and disconnect the charger from the battery.

4． TYPICAL FAULTS AND TROUBLESHOOTING

Fault

Reason

Phenomenon

Unable to

Charger not plugged in

charge

Charger faulty

normally

The terminal is dirty or the terminal is not properly fastened

BMS is in protection mode

Battery circuit fault

Abnormal

Polarity error

discharge

The battery SOC is too low

Battery circuit fault

Abnormal

Operation temperature too high, trigger over temperature protection

discharge stop

Excessive discharge current, triggers over current protection

External short circuit of battery, triggering short circuit protection

5． PRECAUTIONS FOR HANDLING ABNORMAL PROBLEMS

1.This product should be repaired by professional personnel. If you open the battery shell by yourself, the warranty service will be

terminated.

2. If the battery is seriously impacted, compressed, dropped or heated, it must not be used and must be sent to the product agent or after-sales

service office of the company in time for maintenance.

BRANCHES - Johannesburg: 010 202 3300 | Germiston: 011 418 9600 | Cape Town: 021 492 2000 | Riverhorse: 031 492 4800 | Pinetown: 031 700 4215

Processing method

Check charger connector

Replace charger

Clean the terminals and tighten the screws

Disconnect the battery for 30 seconds and

reconnect

Please contact the nearest dealer for repair.

Check polarity

Fully charge the battery before use

Please contact the nearest dealer for repair

Disconnect the load and allow the battery to rest

for half an hour at room temperature

Reduce discharge current

Turn off the device, disconnect the battery,

remove the short circuit and then reconnect