Cisco 3825 Series Quick Start Manual - Page 25

Browse online or download pdf Quick Start Manual for Network Router Cisco 3825 Series. Cisco 3825 Series 38 pages. Integrated services routers
Also for Cisco 3825 Series: Installation And Upgrades (20 pages), Non Proprietary Security Policy (30 pages), Quick Start Manual (40 pages)

Print Page

Table 3

WAN, LAN, and Voice Connections

Port or Connection

Port Type, Color

BRI NT/TE

RJ-45, orange

(built-in NT1)

56/64-kbps

8-pin modular, blue

CSU/DSU

T1/FT1 CSU/DSU

8-pin modular, blue

Gigabit Ethernet SFP,

LC, color according

optical

to optical wavelength

1. The color codes are specific to cables shipped by Cisco.

2. See the

Cisco Modular Access Router Cable Specifications

System Management Connections

The connections described in Table 4 provide system management access.

The USB ports (version 1.1) are intended for future use only.

Note

Table 4

System Management Connections

Port

Console

Auxiliary

Power Up the Router

To ensure adequate cooling, never operate the router unless the cover and all modules and cover plates are installed.

Caution

Checklist for Power Up

You are ready to power up the Cisco 3800 series router after the following steps are completed:

• Chassis is securely mounted and grounded. (See the "Install Chassis" section on page 5.)

• Power and interface cables are connected. (See the "Connect Cables" section on page 15.)

• PC with HyperTerminal or similar terminal emulation program is connected to the console port, powered up, and

configured for 9600 baud, 8 data bits, 1 stop bit, no flow control, and no parity. (See the "Power Connections" section on

page 16.)

• Suitable PC COM port is selected in the terminal emulation program.

• You have selected passwords for access control.

• You have determined the IP addresses for the Ethernet and serial interfaces.

Note

For initial power-up, a direct console connection is recommended. After the initial configuration is completed, a remote

modem connection can be used for router management.

Connection

ISDN terminal equipment and

ISDN network

RJ-48S interface in subrate device

or network

RJ-48C interface

1000BASE-SX, -LX, -LH, -ZX,

-CWDM

Color

Connected To

Light blue PC or ASCII terminal communication port

(usually labeled COM)

Black

Modem for remote access

document for information about selecting these cables.

Cable

RJ-45 straight-through in TE mode

BRI crossover in NT mode

RJ-48 straight-through

Optical fiber as specified on applicable

data sheet

Cable

RJ-45-to-DB-9 console cable

RJ-45-to-DB-25 modem cable or

RJ-45-to-DB-9 console cable and DB-9

to DB-25 adapter