Cisco 4000 Series Replacement Manual - Page 13

Browse online or download pdf Replacement Manual for Network Router Cisco 4000 Series. Cisco 4000 Series 16 pages. Upgrading memory
Also for Cisco 4000 Series: Manual (18 pages), Preparing To Install (11 pages), Installation Manual (18 pages), Upgrade Manual (24 pages)

Print Page

Replacing Connections to the Router

Take the following steps to make the ﬁnal connections to the router:

Warning

Step 1

Step 2

Step 3

Warning

or spade-type with upturned lugs. These terminations should be the appropriate size for the wires

and should clamp both the insulation and conductor.

Warning

using the appropriate lugs at the wiring end, as illustrated. The proper wiring sequence is ground to

ground, positive to positive (line to L), and negative to negative (neutral to N). Note that the ground

wire should always be connected ﬁrst and disconnected last.

Warning

handle and reinstate power by moving the handle of the circuit breaker to the ON position.

Step 4

Step 5

This completes the power supply replacement procedure.

Read the installation instructions before you connect the system to its power source.

Replace all network connections.

If you have an AC-powered system, plug the system power cord into a 3-terminal,

single-phase power source that provides power within the acceptable range

(100–240 VAC, 50–60 Hz, 3.0–1.5 A).

If you have a DC-powered system, rewire the DC-input power supply (40 to 72 VDC) to

the terminal block using 14 AWG copper wires. The proper wiring sequence is ground to

ground, positive to positive, and negative to negative. (See Figure 10.)

When stranded wiring is required, use approved wiring terminations, such as closed-loop

This unit is intended for installation in restricted access areas.

The illustration shows the DC power supply terminal block. Wire the DC power supply

After wiring the DC power supply, remove the tape from the circuit breaker switch

Turn ON the system power switch. The power LED on the front panel of the router should

go ON. )

Check the OK LED on the right side of the front panel to verify that it goes ON after a

few seconds delay when booting. If you have problems, see the section "Troubleshooting

the Power Supply Installation" and the section "Cisco Connection Online."

Replacing Connections to the Router

Replacing the Cisco 4000 Series Power Supply