ACDC Dynamics FL-AC03 Using Instruction

Browse online or download pdf Using Instruction for Security Sensors ACDC Dynamics FL-AC03. ACDC Dynamics FL-AC03 2 pages. Passive infrared detector

Print Page

Passive infrared detector using instruction

INTRODUCTION

The product is a new type of sensor switch; it adopts infrared

energy detector, IC and SMD technology. When one enters the

product's detecting range, the infrared sensor work and output signal

to its matched control unit, the control unit will alarm.

FEATURES

selectable pulse width;

high interference immune;

tamper switch;

preventing pet design;

installation flexible and convenient;

SPECIFICATIONS

power supply:8~16VDC

warm-up time:30s

alarm time:2s

sense degree:140

sense distance:8m(max)

working temperature:-10

relative humidity:<93%RH

installation height:1.5~3.5 m

MOUNTING

Untangle the end screw and open the front cover;

loosen the screw fixing PCB

remove PCB to the end surface, and take out PCB;

bore crossing-line holes on the back cover;

run the wire along the wire slot located on the backside of the back cover and insert

it through its prepared hole.

Fix the back cover on the selected position;

connect power and signal wire to the terminal block according to following diagram,

replace the PCB into back cover.; Set vertical adjustment and tighten the PCB screw;

close the front cover and tighten the screw.

CONNECTION-WIRE

the signal wire is connected directly, when the front cover is opened, the connection is cut

~ +40

℃

；

Terminal 1 connect to negative voltage "-"

Terminal 2 connect to positive voltage " +"

Terminal 5&6

tamper signal wire

—

Connect with controlling unit

down and give

one signal to controlling unit.

Terminal 3&4

RELAY

—

when close the front cover,

，