CAB 5326C Assembly Instructions Manual - Page 11

Browse online or download pdf Assembly Instructions Manual for Industrial Equipment CAB 5326C. CAB 5326C 15 pages. Vacuum-belt applicator

Print Page

Adjustments

Waiting position of the label

Label transport/Reflex sensor

Fig. 6

In the setup menu the setting "Blow on" must be selected in order to change the parameter "Blow time".

After reaching the reflex sensor (1) and detection point (3) the transportation device will continue for a set time to

ensure the label (2) is transported to the pinch roller (4). This time as well as well as the position of the label can be

determined by the parameter:

> Blow time

A higher value causes a longer transport time.

200 ms accord ca. 10 mm

Follow-up Transportation

Once the label (2) leaves the sensor area the transportation module continues for a set time to ensure that the label

reaches the pinch roller and thus the product. This time value is adjustable via the parameter:

> > Support del. on

4.3

Signals

•

With the signal DREE will print the label and move it to the pinch roller.

The signal START will transport the label up till the reflex sensor as well as its application transport to the pinch

•

roller.

In the application-mode "Apply - Print" the printing of the next label will commence automatically as the soon as

the previous label has been applied.

In the application-mode "Print - Apply" the printing of a next label will wait for the the DREE signal.

Signal

Name

DREE

START

Table 2

Pin assignment of the I/O interface

 Interface description of the label printer Hermes C

Description

without applicator

Print signal Prerequisite:

The primary control has

confirmed with the ETE

signal that the previous la-

bel has passed the peel-off

position.

with applicator

Print first label

in mode "Apply-Print"

Start of label print/applica-

tion

Activation/Active State

Switch on +24V between

Pin 1 and Pin 25

+24V between Pin 13 and Pin 25