Cisco Profile Series Installation Manual - Page 40

Browse online or download pdf Installation Manual for Network Router Cisco Profile Series. Cisco Profile Series 44 pages. Jbod on the 12g sas modular raid controller
Also for Cisco Profile Series: Getting Started Manual (41 pages), User Manual (44 pages), User Manual (7 pages), Getting Started Manual (35 pages), Quick Reference Manual (2 pages), Configuration Manual (13 pages), Installation Sheet (2 pages), Installation Manual (2 pages), Quick Start Manual (4 pages), Quick Start Manual (4 pages), Installing Manual (16 pages), Getting Started Manual (32 pages), Manual (16 pages), Getting Started Manual (42 pages), Getting Started Manual (46 pages)

Print Page

The configuration is displayed:

The following configuration command script was created:

hostname Router

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

no ip routing

interface FastEthernet4

no shutdown

speed 100

duplex auto

ip address 172.1.2.3 255.255.0.0

Respond to the following prompts. Enter 2 to save the initial configuration.

Step 12

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started! RETURN

The user prompt is displayed.

Router>

Step 13

Verify the initial configuration. See the

verification procedures.

After the initial configuration file is created, you can use the Cisco IOS CLI to perform additional

configuration.

Verifying the Initial Configuration

To verify that the new interfaces are operating correctly, perform the following tests:

•

After you complete and verify the initial configuration, you can configure your Cisco router for specific

functions.

Cisco 800M Series Integrated Services Router Hardware Installation Guide

4-4

To verify that the interfaces and line protocol are in the correct state—up or down—enter the show

interfaces command.

To display a summary status of the interfaces configured for IP, enter the show ip interface brief

command.

To verify that you configured the correct hostname and password, enter the show configuration

command.

"Verifying the Initial Configuration" section on page 4-4

Chapter 4

Initial Configuration

for