CAB 4114L-300 Operator's Manual - Page 11
Browse online or download pdf Operator's Manual for Printer CAB 4114L-300. CAB 4114L-300 13 pages. Stroke applicator
Print Page
4
Error Messages
4.1
Error Messages of the Printer
For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.) Operator's manual of the printer
Error treatment:
Clear the error results.
Press the feed key to synchronize the label feed, remove the peeled labels manually.
Press the pause key to quit the error state.
After error correction, the printing of the label causing the error will be repeated.
4.2
Error messages of the Applicator
The following table contains an overview of error messages and their possible causes. It also suggests methods to
resolve the problem:
Error Message
Air pressure ins.
Label not depos.
Upper position
Process Error
Refl. sensor blk.
Lower position
Vac. plate empty
Table 2
Error messages of the applicator
Error treatment:
Clear the error results.
Press the pause key to quit the error state.
i
Note!
In the case of an error check the service manual for adjustments and settings.
Warning!
!
The pad will immediately be moved in the starting position!
Danger of crushing hands and fingers by the moving pad!
Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry distant.
After error correction, the printing of the label causing the error cannot be repeated without re-starting the print job.
Except at the error " Vac. plate empty". In this case, the last label will be printed again after the error state has
been quit by pressing the pause key and then by pressing the Enter button
In the application mode "Apply/Print" send the signal "Print first label" or press the button
label to the tamp.
Possible Cause
Compressed air is switched off
Pressure to low < 4 bar
Pressure to high > 6 bar
Label has not been placed onto the product; after the pad has moved back the label is
still sticking to the pad
Pad is not in start position when the printer is switched on
Pad has not reached the labelling position within 2s after the movement of the pad was
started
Pad has left the start position without authorization
Process of labeling was interrupted via the I/O interface of the printer with the XSTP
signal
There was not change in the state of the starting position sensor although the pad has
reached the lower position sensor
Pad has not reached the starting position within 2s after the pad has left the labelling
position; or pad has left the starting position unauthorized
Label has not been picked up properly by the pad; or label fell off the pad before it could
be placed onto the product
.
to send a printed
11