Cisco 1700 series Configuration Manual - Page 17

Browse online or download pdf Configuration Manual for Wireless Access Point Cisco 1700 series. Cisco 1700 series 25 pages. Secure firewall management center
Also for Cisco 1700 series: Regulatory Compliance And Safety Information Manual (45 pages), Manual (15 pages), Application Note (41 pages), Hardware Troubleshooting (12 pages), Overview Manual (13 pages), Configuring (34 pages), Manual (5 pages), Quick Start Manual (6 pages), Hardware Installation Manual (46 pages)

Print Page

After the configuration you entered appears, you are asked whether you want to use it.

Enter yes to save the startup configuration:

Step 8

Use this configuration? [yes/no]: yes

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started!

The configuration is saved. Otherwise, enter no. The information you entered is discarded, and you can

reenter the configuration parameters.

Router Configuration Scenarios

The following examples shows a Cisco 1700 series router configured to use the Cisco WIC-1ENET.

These are sample configurations. For descriptions of the features and commands, see the configuration

guidelines on the Cisco website.

Figure 2

IP/ATM

Example PPPoE Client Configuration

Point-to-Point Protocol (PPP) over Ethernet (PPPoE) offers a familiar dial interface to subscribers over

customer premises equipment (CPE), as shown in

separate PPP sessions. It allows hosts connected to CPE to establish PPP sessions. When the router is

running PPPoE, hosts connected to the router are not required to run individual PPP sessions.

78-11422-03

interface Ethernet0

ip address x.x.x.x x.x.x.x

router igrp 1

redistribute connected

network x.x.x.x

end

Example Configuration

Modem

DSL/Cable

Cisco

1720

12.0.0.x

WIC-1ENET

Figure

2. It allows PCs connected to CPE to establish

Connecting a Cisco WIC-1ENET Card to the LAN

Router Configuration Scenarios