Epson V11H179020 - PowerLite S3 SVGA LCD Projector Product Information - Page 12
Browse online or download pdf Product Information for Projector Epson V11H179020 - PowerLite S3 SVGA LCD Projector. Epson V11H179020 - PowerLite S3 SVGA LCD Projector 15 pages. Supplemental / late breaking information
Also for Epson V11H179020 - PowerLite S3 SVGA LCD Projector: Specifications (2 pages), Installation Manual (19 pages), Quick Setup Manual (7 pages), Specifications (1 pages)
Print Page
Epson PowerLite S3 Projector
Replacing the Air Filter
If you need to replace the air filter, you can obtain it from an
authorized Epson reseller. To find the nearest reseller, please call
800-GO-EPSON (800-463-7766). To purchase online, visit
www.epsonstore.com (U.S. sales only). In Canada, please call
800-463-7766 for reseller referral.
If the air filter is broken or if the warning message reappears
after it has been cleaned, it should be replaced.The air filter can
be replaced even if the projector is installed on a ceiling.
1. Turn off the projector's power. When the confirmation
buzzer beeps twice, disconnect the power cable.
2. Remove the air filter. Put your finger into the recess behind
the air filter tab and slide it forward to remove it.
3. Install the new air filter. Slide the air filter covers in from the
outside and push them in until they click into place.
Note: Dispose of used air filters properly in accordance with your
local regulations. The air filter frame is made of polycarbonate and
ABS plastic. The air filter is made of polyurethane foam.
12 - Epson PowerLite S3 Projector
Replacing the Lamp
It is time to replace the lamp when:
❏ The message "Replace the Lamp." appears on the screen
when projection starts
❏ When the
indicator is flashing orange
Lamp
❏ The projected image gets darker or starts to deteriorate
The lamp replacement message appears after the following
periods of time in order to maintain the initial brightness and
quality of the projected images:
❏ When used continuously at the high brightness setting
(approximately 1900 hours)
❏ When used continuously at the low brightness setting
(approximately 2900 hours)
Note: If you continue to use the lamp after this period, the
possibility of the lamp breaking becomes greater. When the lamp
replacement message appears, replace the lamp with a new one as
soon as possible, even if it is still working. Depending on the lamp
and the way it has been used, the lamp may become darker or stop
working before the lamp warning message appears.
You can obtain a spare lamp from an authorized Epson reseller.
To find the nearest reseller, please call 800-GO-EPSON (800-
463-7766). To purchase online, visit www.epsonstore.com
(U.S. sales only). In Canada, please call 800-463-7766 for
reseller referral.
Caution: If you are replacing the lamp because it has stopped
working, it is possible that the lamp is broken. If replacing the lamp
of a projector which has been installed on a ceiling, you should
always assume that the lamp is broken and be extremely careful
when removing the lamp cover.Wait until the lamp has cooled
down sufficiently before removing the lamp cover. To give the lamp
enough time to cool down after turning off the power, wait for
about one hour.
1. After you turn off the projector's power, and it beeps twice,
disconnect the power cable.
2. Wait until the lamp has cooled down, then remove the lamp
cover from the base of the projector.
3/05
Flashing
orange