Cisco 1800 Series Quick Start Manual - Page 18

Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco 1800 Series. Cisco 1800 Series 28 pages. Cisco ios software configuration
Also for Cisco 1800 Series: Datasheet (16 pages), Configuring (32 pages)

Print Page

Table 4

Interface Numbering

Slot Number

Slot Type

Onboard Ports

Fast Ethernet

Slot 0

HWIC/WIC/VWIC

Slot 1

HWIC/WIC/VWIC

1. The interfaces listed are examples only; other possible interface types are not listed.

2. VWICs are data-only in Cisco 1841 routers.

Note

On the Cisco 1841 router, the numbering format for configuring an async interface is 0/slot/port. To configure the line

associated with an async interface, simply use the interface number to specify the async line. For example, line 0/0/0

specifies the line associated with interface serial 0/0/0 on a WIC-2A/S in slot 0. Similarly, line 0/1/1 specifies the line

associated with interface async 0/1/1 on a WIC-2AM in slot 1.

Perform Initial Configuration

You can configure your router by using one of the following tools:

• Cisco Router and Security Device Manager (SDM)—See the "Initial Configuration Using Cisco Router and Security Device

Manager" section on page 18.

• Setup command facility—See the "Initial Configuration Using Setup Command Facility" section on page 18.

• Command-line interface (CLI)—See the "Initial Configuration Using Cisco CLI—Manual Configuration" section on

page 21.

Initial Configuration Using Cisco Router and Security Device Manager

If the following messages appear at the end of the startup sequence, Cisco Router and Security Device Manager (SDM) is

installed on your router:

yourname con0 is now available

Press RETURN to get started.

For instructions on configuring your router by using SDM, refer to the Cisco Router and Security Device Manager (SDM) Quick

Start Guide that shipped with your router.

If the messages above do not appear, SDM and the Cisco Router and Security Device Manager (SDM) Quick Start

Tip

Guide were not shipped with your router. If you want to use SDM, you can download the latest version of SDM and

instructions for installing it on your router from the following location:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to www.cisco.com/go/sdm

and click the Technical Documentation link.

Slot Numbering Range

0/0 and 0/1

0/0/0 to 0/0/3

0/1/0 to 0/1/3

Example

interface fastethernet 0/0

interface serial 0/0/0

line async 0/0/0

interface serial 0/1/0

line async 0/1/0